APFC Panel
Automatic power factor correction panels that switch capacitor banks in steps to hold your power factor near the target and help avoid utility penalties.
Power Factor & Generator Panels
Auto mains failure panels that start your diesel generator when the grid fails, transfer the load, and switch back when mains power returns.
An auto mains failure (AMF) panel watches the incoming mains supply. When it fails, the panel starts the diesel generator, transfers the load once the DG is ready, and transfers it back when mains power returns, then stops the DG after a cooling period.
We build AMF panels to suit your DG set and load, as standalone panels or as part of a DG-and-mains distribution line-up.
| Parameter | Value |
|---|---|
| DG rating | As per your DG set |
| Changeover | Automatic, interlocked |
| Operating voltage | 380 / 415 / 440 V AC, 3-phase, 4-wire |
| Frequency | 50 Hz |
| Short-circuit rating | Up to 50 kA for 1 s (CPRI-tested); higher on request |
| Degree of protection | Up to IP55 (CPRI-tested) |
| Internal separation | Up to Form 4 |
| Sheet steel | CRCA, 2 mm or 1.6 mm as specified |
| Surface finish | 7-tank pre-treatment, powder coated up to 100 microns |
| Busbars | Aluminium, TPN, rated to the load |
| Standard | IS/IEC 61439-1 and 61439-2 |
Automatic power factor correction panels that switch capacitor banks in steps to hold your power factor near the target and help avoid utility penalties.
Auto synchronising panels that run two or more diesel generators in parallel, share the load between them and feed your distribution.
Send it today for an itemised quote on your panels.